CMTA
You do not need to know whether you need a holder, a fixture or a machine. You need to describe what is going wrong. Each page below starts from a situation and explains what happens next.
Obsolete and unavailable components, imported tooling, setup and cycle time, critical parts and production delays, fixtures and SPMs.
Recreate parts the OEM no longer supplies, from sample to verified replacement.
ExploreLocalise imported holders and adaptors with verified fit and shorter replenishment.
ExploreShorten setups and tool changes with pre-set tooling and quick-locating fixtures.
ExploreFrom datum study to a trialled fixture, designed around your part and process.
ExploreCritical components made to drawing with grinding, coordinated finishing and inspection.
ExploreFind the tooling limit on cycle time and remove it, measured on your machine.
ExploreSample to approved drawing to verified part, with the drawing retained for you.
ExploreUrgent review and manufacture of the part holding up production.
ExploreFrom process study to accepted machine, with risks and acceptance stated up front.
ExploreDiagnose recurring wear, failure or fit problems and engineer the fix.
ExploreUnderstand the requirement, engineer the solution, manufacture it, verify it, support it. What changes between these pages is the symptom you arrived with and the evidence that will tell us it worked.
FAQ
The questions engineers and buyers ask before sending a drawing. If yours is not here, ask it directly — you will get an engineer's answer, not a brochure.
Still have a question?
Talk to Anita M.N, Managing Partner, or send the drawing and let the review answer it.
Yes, through reverse engineering from the sample, with a drawing developed for your approval.
For mechanical holders and accessories, yes — localised from sample or drawing with a fit check on your machine before repeat supply.
With a baseline measurement of current setup or cycle time, followed by tooling analysis, a trial plan and measured results.
Yes. Urgent enquiries are reviewed first and given a realistic timeline.
Start a project
Share what you are trying to make or fix. Our engineering team reviews every enquiry and responds with the questions that matter, a feasibility view and next steps.
